This standard is issued under the fixed designation A /A M; the 1 This specification is under the jurisdiction of ASTM Committee A ASTM A/AM: Standard Specification for Steel, Sheet and Strip, Heavy- Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural. Find the most up-to-date version of ASTM A at Engineering
|Published (Last):||26 February 2013|
|PDF File Size:||19.39 Mb|
|ePub File Size:||14.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Product analysis is appropriate on these types of steel only when misapplication is apparent, or for copper when copper steel is speci? However, under SI, the preferred term is mass.
The values a6355 are not exact conversions of the values listed in the inch-pound tables, but instead are rounded or rationalized values.
A number in parentheses indicates the year of last reapproval. Steels may or may not be subjected to tension test requirement.
ASTM A635 Grade 1018
Conformance to Annex A1 is mandatory when the “M” specification is used. The tip of the spindle shall be? NOTE 2—The term weight is used when inch-pound units are the standard.
Workmanship, Finish, and Appearance 9. Packaging and Package Marking atsm Dimensions and Tolerances 8. However, under SI, the preferred term is mass. The purchaser is advised to discuss this change with the supplier.
Link to Active This link will always route to the current Active version of the standard. The several determinations of any element in a cast shall not vary both above and below the speci? Subscribe to Premium Services Searches: Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Hot-rolled heavy thickness coils 12 in. These tolerances do not include crown, and, therefore, the tolerances given in Table A1. Steel subjected to certain heating operations by the purchaser may not give chemical analysis results that properly represent its original composition.
Notwithstanding the absence of a q635, the organization submitting the document is responsible for the content of the document.
AK Steel ASTM A and A Hot Rolled Carbon Steel, Structural Steel (SS)
The ability of manufacturers to meet the maximum coil weights depends upon individual mill equipment. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Pickled or blastcleaned material has cut edges; if mill-edge material is required, it must be speci?
The analysis shall be from a test sample preferably taken during the pouring of asstm heat or cast.
These tolerances do not include crown, and, therefore, the tolerance given in Table A1. Chips must be well mixed and those too coarse to pass a No. The purchaser is advised to discuss this change with the supplier. However, the document shall clearly identify the organization submitting the document. Data sheets for overmetals, plastics, ceramics, and composites. This specification covers the general requirements for adtm, heavy-thickness, and high-strength low-alloy with improved formability sheet and strip coils.
We appreciate your input. When required, minimum coil weights are subject to atm.